Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
1
WAL-QP8-WP60PM-GRC50
1.
Place tower in desired location that is flat and able to support the quadpod without falling over.
2.
Loosen hand screw and lower legs until firmly stabilizing quadpod.
3.
Tighten hand screw to secure legs.
4.
With help, place the T-head over top pole and tighten hand screw.
Light weight devices can be attached by tilting quadpod toward the ground with the legs up. Attach T-
head to pole, tighten hand screw and tilt back to its vertical position. DO NOT tilt quadpod while
extended to max height. It is recommended to have another person hold the quadpod while tilting
vertically.
For heavy equipment, use a ladder and extra help for attaching T-head to pole.
Double check that all hand screws are tight before continuing use of the quadpod tower.
EXTENDING
1.
Loosen hand screw for extending the T-head. Once loose, extend T-head until desired height
is achieved with at least 1ft - 2ft remaining inside pole for support.
This adjustable and collapsible
quadpod can be extended to twelve feet and collapsed to four and a half feet
WARNING:
DO NOT over extend T-head completely allowing extension pole to free from base! If the
T-
head becomes free, serious injury or death can occur. Larson Electronics shall not be held liable
for
injuries caused by misuse.
2.
When desired height is achieved, tighten hand screw to secure T-head.
LOWERING
1.
To lower mast, grasp T-head and slowly loosen hand screw. Lower the T- head and tighten
hand screw.
WARNING: DO NOT loosen hand screw allowing T- head to fall freely. This can damage the unit and
cause serious injury or death. Always grasp T-head before lowering. Larson Electronics shall not be
held liable for injuries caused by misuse.
The quadpod mount tower can be disassembled for storage or transporting. Unplug attached
equipment from power source and remove T-head following previous steps for attaching.
Once the T-head has been removed, loosen hand screw for legs and fold them up. Wheel to desired
location or remove from wheel base for complete disassembly.
