NMS044 Reference Manual
Install Pole and EPS2116 to System
3-4
Step 4
Holding windscreen and birdspike over the top, screw the
assemblies together (this can wait until after calibration,
see “Calibrate” on page 3-8.
TAKE NOTE
Step 4 can be done
after calibration, see
“Calibrate” on page 3-8.
CAUTION
If you need to
remove the windscreen, do
not pull it off the birdspike
with an upward motion. First,
unscrew the birdspike by
twisting its top and then pull
the windscreen down over the
bottom of the unscrewed
birdspike.
3.4 Install Pole and EPS2116 to System
Step 1
Remove the protective cap from the top and the bottom of
the telescoping pole. Place guy wire ring on the top of the
pole. Place the EPS2116 on top and hold it still, twist the
pole only, making sure to have the signal cable between
two of the tie downs of the ring to not over strain the
cable.
FIGURE 3-6
EPS2116 to Telescoping Pole
