NMS044 Reference Manual
Ready Battery
2-2
Step 3
Place the mounting plate back into the case, over the
battery, until set all the way in.
Step 4
If installing a BAT020, insert foam block to fill empty space
by the terminals.
FIGURE 2-1
Battery Installation
TAKE NOTE
The 831C power
button
0
controls the power
in the whole system. It is used
to turn off and on the
NMS044. Additionally,
connecting the battery will
also turn the system on.
2.2.2 Charge Battery
It is recommended that you charge the battery prior to deployment. A
PSA039 AC Battery Charger is included for this purpose. Connect the
solar connectors together, and use the plug to connect to an external
power source (wall outlet) until charged. You will know it is fully
charged when the PSA038 Genasun Solar Charge Controller is green
(blinking indicates it is charging, constantly on indicates charge is full),
see A.5.3 "PSA038 Genasun Solar Charge Controller" on page A-5.
If there is no light, ensure the battery is properly installed and the
system is turned on.
CAUTION
The yellow
connector does not
connect in the power
block. Do not attempt to
connect the yellow
connector to a red or black
connector.
