NMS044 Reference Manual
Configure the RV50 Gateway
2-4
RV50, press in to slot until it clicks. Screw the door closed
again.
FIGURE 2-3
RV50 Sim Card Slot
Step 3
Remount the modem in the case with the two screws.
Hand tight.
2.3.2 Configure for Remote Communication
TAKE NOTE
If you’ve purchased
the RV50 Gateway separately
or it has been reset to factory
settings, you will need to
upload the LD settings first
before you can configure for
remote use. For procedures
on loading the LD settings,
see A.7 "Configuring LD
Settings for the RV50" on page
A-7.
You will need to configure your gateway for remote communication
prior to deployment. Once the gateway is installed with a SIM card, and
the charged battery is assembled, you are ready to begin.
To setup for remote communication, follow these steps:
Step 1
The Ethernet port on the gateway has been disabled for
power saving reasons and cannot be used to connect to.
Disconnect the USB cable which is connected to the
gateway, using a separate USB cable, connect the gateway
directly into your computer. The USB cable now connects
the RV50 gateway to your PC.
FIGURE 2-4
Connecting to RV50
USB Cable
Connect separate mini B USB
cable into the RV50 and to a PC
Unplug USB cable
