Lars Thrane LT-3100, Руководство пользователя и инструкция по установке

Страница: 4 / 167

LT-3100 User & Installation Manual Rev. 1.06 Introduction
Lars Thrane A/S www.thrane.eu ii
WARNING - Product installation
To ensure correct performance of this equipment,
it is strongly recommended that professionals with
expertise, properly trained, and likewise authorized
within the industry is completing the installation.
Safety Instructions for Installer & Operator
The following safety instructions must be observed during all phases of operation, installation, service and
repair of this equipment. Failure to comply with these precautions or with specific warnings elsewhere in
this manual violates safety standards of design, manufacture and intended use of the equipment.
Lars Thrane A/S assumes no liability for the customer's failure to comply with these requirements.
Instructions for the Installer Instructions for the Operator
WARNING – Do not disassemble
Do not disassemble or modify this equipment. Fire,
electrical shock, or serious injury can result.
WARNING – Keep away from live circuits
Operational personnel must not remove product
enclosure. Do not service the equipment with the
communication cable connected. Always
disconnect and discharge unit, cable and circuits
before touching them.
WARNING – Turn off power switch
Turn off the main power switch before installing
the equipment described in this manual. Do not
connect or disconnect equipment when the main
power switch is on.
WARNING – Use only the supplied cable
Use only the supplied power and communication
cable for connecting the equipment.
WARNING - Permanent watch
In case of smoke or water leaks into the
equipment, immediately turn off the power.
Continued use of the equipment can cause fire or
electrical shock. Keep access and permanent watch
of the equipment in order to prevent any
unwanted escalation.
WARNING – Input Power
The input voltage range is: 12-24 VDC.
WARNING – Power supply protection
Make sure that the power supply is adequately
protected by a fuse or an automatic circuit breaker
when installing the equipment (max. 7.5 A).
WARNING - Explosive atmosphere
Do not operate the equipment in the presence of
flammable gases or fumes. Operation of any
electrical equipment in such an environment
constitutes a definite hazard.
WARNING - Compass safe distance
The compass safe distance for standard and
steering compasses is 1.40 m (4.6 ft) and 0.90 m
(3.0 ft) respectively. Observe these distances to
prevent interference to a magnetic compass.
IMPORTANT - Safety distance
The safety distance from the LT-3130 Antenna
Unit, when the LT-3130 Antenna Unit is powered
and transmitting, is 0.1 m (0.3 ft), to comply with
the regional regulations.
Always keep this safety distance to the LT-3130
Antenna Unit to avoid any serious injury.
If the safety precautions and warnings on this site are not followed, warranty will be void.
WARNING – DC mains connector
The DC mains connector is to be used as the
disconnection device to isolate the equipment
from the mains supply.