Appendix A: Command Reference
xPico® Wi-Fi® Embedded Device Server User Guide
78
value CP
This is the number of the Configurable Pin (
CP
) assigned to the role.
Enter blank or 0 to revert to <No CP Selected>.
Blank the value for "<No CP Selected>".
value State
The
Enabled State
allows the application to use the designated Configurable Pin.
Note that some Roles (those containing a ".") are bundled into a group. Enabling / Disabling any one of
them also Enables / Disables the rest of the Roles in the same Group.
State
may be "Enabled" or "Disabled".
value Assert
Assert
reflects the logical polarity of this Configurable Pin.
High
means that a logical "1" corresponds to a voltage high condition on the pin.
Low
means that a logical "1" corresponds to a voltage low condition on the pin.
Assert
may be "High" or "Low".
value Mode
Mode
indicates if this Configurable Pin is set up for push-pull or if it enables an internal weak pullup.
5-Volt tolerance:
In order to sustain a voltage higher than VDD+0.3, the Mode must be set to Push-Pull.
Mode
may be "Push-Pull" or "Weak Pullup".
configgroup HTTP Server
These settings pertain to the
HTTP Server
.
Changes will take effect after reboot.
configitem State
value
Enable
the
State
to allow the HTTP Server to operate.
Disable
the
State
to prevent HTTP from operating on any port.
State
may be "Enabled" or "Disabled".
configitem Port
value
The
Port
can be overridden. Blank the display to restore the default.
Zero the value for "<None>".
configitem Inactivity Timeout
value
The
Inactivity Timeout
applies only if the Application "HTTP Server" is enabled in Performance.
The HTTP Server will hold power on this long after it completes a request.
Inactivity Timeout
has units of seconds.
