SDS1100 User Guide
3: Configuring the Unit
For example, to set Channel 1 parameters:
1.
Type
1
in the
Your choice?
field and press
Enter
.
Figure 3-7. Channel 1 Configuration
2. In
the
Baudrate
field, accept 9600 by pressing
Enter
or enter the speed you
wish to use.
3. In
the
I/F Mode
field accept the default (4C) or change the I/F (serial) settings.
4. Continue entering the listed parameters, or accept the defaults by pressing
Enter
:
5. When you are finished entering all of the parameters (all options), save the new
configurations (option
9
). The unit will reboot.
Using the Serial Port
For local configuration, a terminal or a PC running a terminal emulation program can
be connected to the unit’s serial port (channel 1). The terminal (or emulation) should
be configured for 9600 baud, 8-bit, no parity, 1 stop bit, and no flow control.
1. Cycle the unit’s power (power off and back on). After power-up, the self-test
begins and the diagnostic and status LEDs start blinking.
2. Type three lowercase
x
characters (
xxx
)
within one second
after powering up
in order to start the configuration mode. The Setup Mode window displays.
(See the example in
Using a Telnet Connection.
)
Note:
The easiest way to enter Setup Mode is to hold down the x key on
your keyboard while powering up the unit.
3. Select an option on the menu by entering the number of the option in the
Your
choice ?
field and pressing
Enter.
32
Содержание SecureBox SDS1100
Страница 1: ...Part Number 900 354 Revision A April 2004 SecureBox SDS1100 User Guide ...
Страница 5: ...SDS1100 User Guide 5 ...
Страница 15: ...SDS1100 User Guide 1 Introduction 15 ...
Страница 53: ...SDS1100 User Guide 4 Updating Firmware 53 ...
