20
Flow Chart
Chapter 4
Embedded and Industrial Computing
Chapter 4:
The Flow Chart
The flow chart section contains all flow chart used in the
system. The flow chart describes the system’s behavior on
powering on and off the system via power ignition control
or on/off switch when the appropriate timer control
parameters are set.
Note:
For power-good and low-voltage
1.
mechanism to function in the workflow,
you will need to enable the power-good
and low-voltage detection function with
selector 1
and
selector 2 of
jumper SW1
respectively of
the LVB-5550
board.
(Refer to
Chapter 3 Board Layout
).
For power on and power off delay timer
2.
parameter, refer to
Appendix A Using the
Ignition System Manager (ISM)
.
When the system’s shutdown timer starts
3.
counting down 180sec, using ignition
or External PWR_BTN to start the system
again during shutdown process will not
work until the countdown finishes.