Lankota CK1100, Руководство пользователя

Страница: 19 / 38

5/19/2021 www.lankota.com | Lankota Inc. Page | 19
Lankota is a registered trademark of Lankota Group.
Hammer Installation/Replacement
1. Each of the 60 hammers is double - sided/reversable. After one side is worn
down, remove the roll pin, washer and clevis pin.
2. Flip the hammers and reinstall the hardware.
3. When both sides are worn or the tip is less than 5 - 3/4” from the center of the
pivot hole, call Lankota for replacement hammers.
All hammers must be installed; failure to have all hammers and hardware
installed will cause the mill to be unbalanced inducing vibrations that
significantly shortens the lifespan of components.
If a coarser grind is desired, Hammer Delete Spacers (LANCK114) are provided.
Remove ONLY one hammer and spacer/washer from each set and replace with a
delete spacer . Alternate which hammer is replaced so they are not all in a row.
Failure to not evenly replace hammers will cause the mill to be unbalanced
inducing vibrations that significantly shortens the lifespan of components.
Store the hammers & washers on the rear of the Corn Cracker.
Tip Length
More than 5 - 3/4”