Lankota CK1100, Руководство пользователя

Страница: 26 / 38

5/19/2021 www.lankota.com | Lankota Inc. Page | 26
Lankota is a registered trademark of Lankota Group.
Drum Spacing/Ticking
The drum is centered, squared and locked in place during assembly, but transport and some use
may cause it to shift/settle. If the hammer mill produces a ticking/knocking sound when spinning,
the drum may not be correctly centered in the housing anymore and the heads of hammer pins
may be hitting the inner walls.
•
Remove the front and rear Hammer Access Panels (LANCK109) and shaft guards.
•
Examine the pin heads and determine where the sound is coming from.
•
Loosen the Allen set screw and collar on each bearing.
•
Tap/slide the drum forward or back as needed until it is centered.
•
Reset the lock collars and set screws before hand - spinning the drum; listen and observe if
it hits anymore.
•
Reinstall all panels and guards.