Lanier Copier System Edition, Руководство по эксплуатации

Страница: 535 / 1270

Basic Copying
34
1
When Copying onto OHP
Transparencies or Thick Paper
To make copies onto OHP transpar-
encies or thick paper, you need to
specify the paper type.
⇒
p.34 “When
Copying onto Custom Size Paper”,
p.36 “When Copying on the Back Side
of the Paper”
Note
❒
Copying onto OHP transparencies
or thick paper may take about 2
minutes.
AAAA
Open the Bypass Tray, and then
adjust the guides to the paper
size.
Important
❒
If the guides are not flushed
with the copy paper, a skewed
image or paper misfeed might
occur.
BBBB
Gently insert the OHP transpar-
encies or a thick paper face up un-
til the beeper sounds.
Important
❒
When you load an OHP trans-
parency, make sure that its front
and back faces are properly po-
sitioned.
❒
To avoid paper misfeeds, fan
the paper before loading it in
the tray.
CCCC
Press the
{{{{
#
}}}}
key.
Display for “Bypass Tray Paper” is
shown.
DDDD
Select [ OHP Sheet ] or [ Thick Paper ] .
EEEE
Press
[ OK ]
.
FFFF
Place your originals, and then
press the
{{{{
Start
}}}}
key.
Important
❒
When copying onto OHP trans-
parencies, remove copied sheets
one by one.
GGGG
When your copy job is finished,
press the
{{{{
Clear Modes
}}}}
key to
clear the settings.
When Copying onto Custom
Size Paper
Important
❒
You should specify the size of copy
paper to avoid paper misfeeds.
AAAA
Open the Bypass Tray, and then
adjust the guides to the paper
size.
Important
❒
If the guides are not flushed
with the copy paper, a skewed
image or paper misfeeds might
occur.
BBBB
Gently insert the paper face up
until the beeper sounds.
The
k
indicator on the display au-
tomatically goes on.