Landoll Till 'N Seed BPS6, Руководство оператора

Страница: 15 / 58

2-1
Chapter 2
Operation
Operation of Till ‘N Seed
Your BRILLION TILL 'N SEED is fully assembled from
the factory. This section refers to how to
successfully operate your machine. Refer to the
Parts Manual 3P092 for complete part breakdowns.
Be sure to read and understand the Safety
Procedures and Cautions starting on page 1-2.
"Left" and "Right" designation is determined by facing the
direction the machine will travel during field operation,
unless otherwise stated.
• If pre-assembled parts or fasteners are temporarily
removed, remember where they go. It is best to keep
parts separated.
• Check that all working parts move freely, bolts are tight
and cotter pins are spread.
• Refer to the Torque Chart in Chapter 4 for proper bolt
torque values.
Note the different torque requirement for bolts with lock
nuts. Refer to Torque Chart in Chapter 4.

DANGER

WARNING
Figure 2-1: Till ‘N Seed Concept
Always be sure the front of the tractor has
enough weight to maintain control when the
machine is raised.
When transporting on roadways, obey all
applicable laws and regulations.
Do not transport at speeds over 20 mph under
good conditions. never travel at a speed which
does not allow adequate control of steering or
stopping.
Avoid sudden stops or turns because the weight
of the machine may cause the operator to lose
control of the tractor.
Make sure your slow moving vehicle sign is clean
and visible.