Landoll Till 'N Seed BPS6, Руководство оператора

Страница: 24 / 58

2-10 3P091
OPERATION
Seed Rate Calibration
Place Calibration Trough in Collection Position by
removing (6) six Carriage Bolts. See Figure 2-11. Place
tarp under front of machine. Refer to Seed Charts on the
Seedbox Covers to determine initial Seed Meter Settings.
If you need to close Seed Meters more than 1/8" for
reduced output when there is seed in the Meters, you
must turn the Seed Shaft while making the adjustment to
prevent damage to the rotating washers and retainer
rings in the Seed Meters. The wrench provided with the
machine can be used for calibration purposes.
Front Seedbox
1. Identify lowest Transmission Range expected to
achieve Seed Rate.
2. Adjust Seed Meter Setting.
3. Remove Seed Drive Disconnect Pin - Front Box.
4. Prime Meters: Turn 5/8" Hex for Front Box Calibration
CW (Clockwise) until all Meters are discharging
seed. Empty Calibration Trough or Tarp.
5. Turn the 5/8" Hex CW 252 (low range), 528 (mid
range) or 771 (high range) revolutions to meter out
seed.
6. Weigh the seed = Lbs / Acre.
7. Adjust Meters and Re-Calibrate as necessary.
8. Ensure Transmission is set-up for proper Seeding
Range.
9. Re-Install Seed Drive Disconnect Pin - Front Box.
10. Re-Install Calibration Trough in Seeding Position.
Figure 2-10: Front Seedbox Calibration
)URQW%R[
+H[7XUQ&:
5HPRYH.OLN3LQWRGLVHQJDJH
)URQW%R['ULYH
5HDU%R[+H[
7XUQ&&:
6WRUDJHKROHIRU
.OLN3LQ