Landoll Drexel SLT30 AC, Руководство оператора

Страница: 77 / 90

OPERATOR’S DAILY CHECKLIST
5-11
Forks

CAUTION
Electrical Fastener
Connections
Check for loose electrical
connections and frayed or broken
wires.
Check for loose electrical
connections and frayed or broken
wires.
Hydraulic Cylinders,
Fittings and Hoses
Check underneath the truck for
evidence of fluid leaks. Look for
hydraulic hose wear, damage and
leaks. Make sure clamps and fittings
are tight. If leaks are found, have
service repair all leaks immediately
and check the hydraulic fluid level.
DO NOT use the truck.
Hydraulic Oil
1. Lower the mast.
2. Open the access door on the
right hand side of the truck and
pull the dipstick and ensure the
oil level reads between the
marks.
NOTE
If the truck has been in operation, let
the truck sit for several minutes
before checking the oil level to allow
time for oil to return to the tank.
3. Add oil if oil level is low.
Operator Controls
Joystick Lift/Lower Control
With the key switch turned “ON”
raise the mast. The hydraulic motor
should start running as soon as the
control is moved out of the neutral
position and stop as soon as the
control returns to the neutral
position. The motor should not run
at all when lowering the mast.
• DO NOT service carriage
forks while the key switch is
“ON”. If the joystick is
accidentally moved, serious
injury could occur.
• It is recommended to use
only Landoll Corporation
replacement parts. Use only
quality forks that are forged
or have an up-set heel and
that have the same capacity
rating as the factory installed
forks.
• NEVER use forks repaired
by welding.
• Always replace both forks.
Switching forks from one
truck to another can be
dangerous if the capacity of
the forks is not known.
• Check the forks for
cracks, closely at the heel
portion of the forks. Replace
the fork if cracks are found.
NEVER attempt to repair,
weld or alter a fork.
https://www.forkliftpdfmanuals.com/