Landoll Brillion WFPC23, Руководство оператора

Страница: 72 / 78

4-12 F-1108-0121
TABLE OF CONTENTS
Acre Meter Troubleshooting
IMPORTANT
Acre Meter is dust and splash resistant, under no
circumstances should this unit be submerged in any
conductive, corrosive, or flammable liquid. At no
time use high pressure water or air to clean it, as this
can damage the unit.
a
Figure 4-10: Acre Meter Notice
NOTE
The ground wire is for static discharge protection and has
no effect on the ability of the sensor to function properly
under normal conditions.
The battery operated Acre Meter uses 3 AA batteries. The
Acre Meter will display
“LObat” when the batteries
require replacement. Remove the Acre Meter from the
implement and then the 4 Screws on the back of the case.
Separate the housing from the rear plate. Replace with 3
quality AA batteries.
Acre Meter does not count pulses during calibration
or does not count acres during operation
.
1. Check the position of the Magnet Wheel Assembly
and Pick-up Switch against the set-up instructions in
this manual.
See Figure 2-25.
2. Verify that the magnet in the Magnet Wheel Assembly
has not come out.
3. Place the Acre Meter display in “Calibrate” mode by
pressing the *(FUNC) key until the P-Word indictor is
lit and then press the up/down arrow keys until the
display shows 0 and the LED is blinking. Break the
connection between the display and the Pick-up
Switch and short between pins A and B on the display
harness connector. You should see the display
inc1 with each contact of the connector
terminals.
4. If step 3 works then wave a magnet in front of the
Pick-up Switch face with it re-connected to the display
and see if the display increments up. If not, put an
ohm meter or continuity tester on the contacts of the
Pick-up Switch harness and place a magnet in front of
the Pick-up Switch face. The Pick-up Switch should
show continuity or near 0 ohms resistance.
Acre Meter can not change the width or pulse count
settings or clear the field and total acres.
1. Check to see if a password needs to be entered by
pressing the *(FUNC) key until the P-Word indicator
LED is lit. If “dIS” is displayed (password disabled) no
password is set.
2. If “Ent” is displayed a password must be entered to
change the settings or the password must be disabled
as instructed in the setup section of this manual.
Storage
1. The service life of the Seeder will be extended by
proper off-season storage practices. Prior to storing
the unit, complete the following procedures:
a. Completely clean the unit, blow all seed out of
meters.
b. Inspect the machine for worn or defective parts.
Replace as needed.
c. Repaint all areas where the original paint is worn
off.
d. Apply a light coating of oil or grease to exposed
cylinder rods to prevent them from rusting.
e. Lubricate each point of the machine as stated in
“Lubrication Maintenance” on page 4-4 .
2. Store the unit in a shed or under a tarpaulin to protect
it from the weather. The ground tools and tires should
rest on boards, or some other object, to keep them out
of the soil.
3. If the unit is stored in the folded position, raise the
machine and install Transport Lock Pin. Lower
Drawbar Jack.
See Figure 3-6.
a. Relieve Hydraulic Pressure in hoses after
Transport Lock Pin is installed.
b. Block wheels before unhitching from tractor.