Landoll Brillion WFPC23, Руководство оператора

Страница: 40 / 78

2-26 F-1108-0121
TABLE OF CONTENTS
Warning Lamp Installation
NOTE
Be sure when assembling Lamps onto Brackets that the
wires are not pinched when tightening hardware.
1. Attach Red Lamps to Frame Light Brackets located
under the Rear Center Frame Tube, using 1/4-20 x
1-1/2 Bolts and Locknuts. Ensure the Red Lens is rear
facing.
See Figure 2-22.
2. Place the Amber Lamps inside the Light Shields,
ensure 2 prong plug sticks out the light shield slot
opening. Attach an Amber Lamp and Shield to Frame
Light Brackets located on Center Frame Bearing
Hangers with 1/4-20 x 1-1/2 Bolts and Locknuts.
3. Attach the Light Module under the Frame Light
Module Mount located on top of the Front Center
Frame Tube with 1/4-20 x 1-1/2 Bolts and Locknuts.
4. Route the flat end of the 7-Pin Harness inside and
through the right side of the Drawbar Frame. Connect
Harness to the Light Module. Route the Harness
7-Pin Plug end with the Hydraulic Hoses down the
Drawbar and through the Hose Support.
IMPORTANT
Cords are marked Left (Yellow Tape) and Right (Green
Tape).
5. Lay out the Lamp Harness, noting that the connectors
marked with Green Tape is Right Side and Yellow
Tape is Left Side. Plug the Lamp Harness into the
Flasher Control Module.
6. Route the 2 prong plug Green Tape cord along the
right side of the Front Frame Tube and the 2 prong
plug Yellow Tape cord along the left side of the Front
Frame Tube. Plug the cords into the Amber Lamps.
7. Route the 3 prong plugs, Green and Yellow cords,
down the Frame Cross Tube and the Rear Frame
tube to the first Red Lamp. Connect Green cord to RH
Red Lamp. Continue running the Yellow cord along
the Rear Frame Tube to LH Red Lamp and connect.
8. Bundle and secure excess cord to the Light Brackets
with Tie Wraps. Secure both Harnesses with Tie
Wraps along the frame and Hydraulic Hoses making
sure to leave enough slack where the Drawbar meets
the Frame for the machine to raise and lower.
9. Raise, lower, fold and unfold machine to check for
proper clearance, adjust accordingly.
NOTE
All Harnesses must be firmly attached to machine frame
members or Hydraulic Hoses so they do not sag or
become torn loose by field debris. Use the tie wraps
provided. Check to be sure the Harnesses is slack
enough so as to not be stretched or interfered with while
raising and lowering of the machine.
SMV Sign Installation
Attach the SMV sign to Bracket located on the Rear
Frame Tube with 5/16-18 x 1 Bolts, Flat Washers and
Locknuts.