Landoll Brillion WCC, Руководство оператора

Страница: 24 / 84

2-8 9J577-0822
TABLE OF CONTENTS
Drawbar and Transport Lock
Installation
1. Position Drawbar with the decal on top. Attach to the
three inner frame tubes using 1-1/4 x 8-3/4 Pin, Flat
Washer and Slotted Pin.
2. Attach the Safety Chain with 1-8 x 3-1/2 Bolt, Flat
Washers and Locknut.
3. Install the Hitch using the 1-1/4-7 x 9-1/2 Bolt and
Locknut.
4. Attach the Hose Support with 5/8-11 x 2 Bolt, Flat
Washer, Lock Washer and Nut.
5. Attach the Drawbar Jack to the Jack Swivel on the
inside of the Drawbar and secure with attached pin.
6. Mount the Manual Canister to the Instruction Tube
Bracket located on inside Left Drawbar Tube and
secure using two Hose Clamps.
7. Insert the Float Link between the two Drawbar Lugs
on the top of the Rear Tube.
8. Place the two Side Plates, single hole end on the
outside of the Float Link, slide Clevis Pin through the
holes secure with Flat Washer and 3/16 x 1-1/2 Cotter
Pin.
9. On the two hole end of the Side Plates, position Tie
Bar between and line up both holes, slide Clevis Pins
through the holes secure bottom hole with Flat
Washer and 3/16 x 1-1/2 Cotter Pin. Secure top hole
with Flat Washer and Hair Pin Cotter, which is the
Transport Lock. When the machine is not in transport
position the Clevis Pin should be stored in the storage
hole located at the top of the Center Frame Cylinder
Frame Lug.
10. Attach Tie Bar to Center Frame Cylinder Lug lower
hole. Secure using Clevis Pin, Flat Washer and 3/16
x 1-1/2 Cotter Pin.
11. Attach base end of 3 x 6 Hydraulic Cylinder to Center
Frame Cylinder Lug top hole. Attach the rod end of
cylinder to the front hole on the Float Link and secure
with existing hardware.
12. Check to ensure there is no binding.