Landoll Brillion SS4, Руководство оператора

Страница: 32 / 56

3-6 7K555-2401
OPERATION
TABLE OF CONTENTS
Front Seed Box Seed Rate
Adjustment
WARNING
NOTE
To avoid Seed Meter damage, if there is seed in the
Meters, decrease rate in small increments. Decrease rate
no more than one nut revolution and rotate Seed Shaft to
purge seed from Meters. Continue adjustment as needed.
NOTE
Before filling with seed be sure Seed Shaft turns freely
and Seed Meters are free of any foreign matter.
Wrenches for adjustment are stored on a Pin on the
Seeder Frame RH End Plate.
Figure 3-7: Adjustment Wrenches
Seed Rate Charts specific to Seeder Model are located
inside the Seed Box Cover and in this manual.
See
Figure 3-15. It should be used as a reference only.
Because of seed variation, a more accurate rate can be
determined by performing
Front Meter Box Seed
Calibration Procedure to calibrate the seed.
On the right side Seed Shaft Extension, the Seed Rate for
the Seed Meters can be set by adjusting the inner or outer
5/8-11 Adjusting Hex Nut on each side of the bearing.
See
Figure 3-8.
IMPORTANT
Do Not Loosen the Seed Shaft Extension Set Screw
when adjusting the Seed Rate. Set screw is only
loosened when zeroing out the Seed Meters. See
"Seed Meter Adjustment" on page 4-6.
1. To increase the rate of seeding, loosen the inner
5/8-11 Adjusting Hex Nut with supplied wrenches.
Back the inner 5/8-11 Adjusting Hex Nut away from
the Bearing. Turn the outer 5/8-11 Adjusting Hex Nut
until the Pointer is aligned with the notch in the Seed
Shaft Extension Hex for the desired Seed Rate.
Tighten the inner 5/8-11 Adjusting Hex Nut against
the Bearing inner race.
2. To decrease the rate of seeding, loosen the outer
5/8-11 Adjusting Hex Nut with supplied wrenches.
Back the outer 5/8-11 Adjusting Hex Nut away from
the Bearing. Turn the inner 5/8-11 Adjusting Hex Nut
until the Pointer is aligned with the notch in the Seed
Shaft Extension Hex for the desired Seed Rate.
Tighten the outer 5/8-11 Adjusting Hex Nut against
the Bearing inner race.
Seed Meters discharge to the front of the machine to aid
the operator in determining proper operation.
Figure 3-8: Seed Meter Adjustment
• To prevent damage to the seed meters, do not
apply excessive force to adjusting nuts. Failure
to do so may result in seed being pinched
between the cut-off and washer inside the seed
cup.
• Do not close the meters more than 1/8" when
there is seed in the meters without rotating the
seed shaft. This prevents damage to the
rotating washers and retainer rings in the seed
meters.
• Do not attempt to open the meters more than
1". (Feed rolls could become disengaged from
the washer in the seed cup.)
Wrenches
Hair Pin
Cotter
Frame
RH End Plate
Bearing
Seed Shaft
Pointer aligned
with notch
Seed Shaft
Extension Hex
DO NOT
adjust
Set Screw
Outer
Adjusting Hex
Nut,5/8-11
Inner
Adjusting Hex
Nut,5/8-11