Landoll Brillion SS4, Руководство оператора

Страница: 30 / 56

3-4 7K555-2401
OPERATION
TABLE OF CONTENTS
SMV Position in Transport
The SMV should be clearly viewable from the rear of the
Seeder and as vertical as possible when in transport.
1. Loosen the 1/2-13 Hardware attaching the SMV
Mount to the Seeder. See Figure 3-4.
2. Pivot the SMV Mount so that the SMV is vertical
(perpendicular to the ground) when the Seeder is in
transport.
3. Re-tighten the 1/2-13 Hardware.
Figure 3-4: SMV Position In Transport
Skid Steer Preparation -
Attaching/Detaching
Skid Steer Preparation
1. The Seeder Quick Attach Plate is designed to be used
with a Skid Steer quick attachment system. Be sure
Skid Steer operating capacity and tire capacity is not
exceeded by the Laden Mass of the Seeder.
Refer to
Skid Steer Operator's Manual.
2. Be sure Skid Steer is properly ballasted to maintain
stability. Calculate the Loaded Seeder mass. (Seeder
weight plus the seed box capacity with desired seed.)
See "Specifications" on page 5-1. Install Rear
Counter Weights if necessary. Refer to Skid Steer
Operator's Manual.
3. Check the Skid Steer tire inflation levels to ensure that
they are properly inflated for the additional Laden
Seeder Mass.
Refer to the Skid Steer Operator's
Manual.
Attaching Skid Steer to Seeder
WARNING
DANGER
DANGER
1. Ensure that there is no debris on the Skid Steer
Mounting Plate and on the Seeder Quick Attach Plate.
2. Disengage the Skid Steer Mounting Plate Lock Pins.
Visually check to make sure that the Lock Pins are
fully retracted.
3. Mate the Skid Steer Mounting Plate into the Seeder
Quick Attach Plate. Tilt the Skid Steer Mounting Plate
forward and slowly engage the underside of the
Seeder Quick Attach Plate Saddle. As the Seeder
Quick Attach Plate is raised and rolled back, the back
surface of the Seeder Quick Attach Plate comes to
rest flat against the front surface of the Skid Steer
Mounting Plate. When the Seeder Quick Attach Plate
is fully supported by the Skid Steer Mounting Plate,
engage the Skid Steer Mounting Plate Lock Pins into
the Seeder Quick Attach Plate. Always visually inspect
the Skid Steer Mounting Plate Locking Pins to make
sure that they are not damaged and are fully engaged
in the Seeder Quick Attach Plate before operating.
Ground
SMV
SMV
Mount
Pivot
Hardware,
1/2-13
Seeder
raised
To prevent machine from tipping backward on the
frame, disengage Parking Pins only when the
Seeder is attached to the Skid Steer. Be sure to
observe the following sequences.
Never get out of Skid Steer by going under the
boom and attachment.