Landoll Brillion SS4, Руководство оператора

Страница: 15 / 56

2-1 7K555-2401
TABLE OF CONTENTS
Chapter 2
Assembly
The Seeder is shipped completely assembled. See
Figure 2-1.
CAUTION
WARNING
DANGER
DANGER
NOTE
Refer to the repair parts manual 7K554 for identification of
parts and for the approximate relationship of the parts in
assembly.
To ensure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use lock washers or
flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts evenly
to prevent misalignment, distortion or binding. Tighten all
screws and nuts to the recommended torques.
IMPORTANT
• If pre-assembled parts or fasteners are
temporarily removed, remember where they go. It
is best to keep parts separated.
• Check that all working parts move freely, bolts are
tight and cotter pins spread.
• Refer to the Torque Table for proper torque
valves. Note the different torque requirements for
Bolts with Locknuts. See Page 4-1.
“Left” and “Right” refer to directions seen as if standing
behind the machine with the 3-PT Hitch in front.
See
Figures 2-3, 2-3, and 2-4.
IMPORTANT
All harnesses must be firmly attached to machine
frame members so they don’t sag or become torn
loose by field debris. Use the tie wraps provided.
Figure 2-1: SSBP6 Seeder
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
Do not attempt to lift heavy parts manually. Use a
hoist or a fork lift to move these parts into
position.
Never get out of the Skid Steer by going under the
boom and attachment.