Landis S-500, Руководство оператора

Страница: 10 / 32

9
ACCESSORIES
EYE PROTECTION SHOULD ALWAYS BE WORN BY THE OPERATOR AND OTHERS IN THE WORK AREA WHEN USING THE
ACCESSORIES SUPPLIED WITH THE LANDIS SANDER. EYE PROTECTION IS REQUIRED FOR PROTECTION FROM FLYING
DEBRIS AND DUST, WHICH COULD CAUSE EYE INJURY.
ACCESSORIES ON QUICK CHANGE BAYONET FITTING:
Both ends of the sanding shaft are machined to accommodate bayonet fitting (quick
change). Extra tools and sanding wheels are available on request. See the list at the end of
this book.
When removing the quick change fittings, use the special spanner
wrench supplied with the machine. To remove, engage the
spanner in the hole near the end of the bayonet fitting and apply a
sharp rap downward. Before putting on a fitting be sure the
machine surfaces are clean. Hand tightening is sufficient to hold
the fitting in proper position.
FAILURE TO PROPERLY MOUNT THE ADAPTOR WILL RESULT IN FLYING APART AND POSSIBLE INJURY TO THE OPERATOR
AND OTHERS IN THE WORK AREA.
THESE QUICK CHANGE ACCESSORIES SHOULD BE PROPERLY ENGAGED ON THE SHAFT TO ENSURE SAFE OPERATION.
MAKE SURE PIN ON SHAFT ENGAGES THE ADAPTOR CORRECTLY
.
SPANNER WRENCH
When removing the quick change fittings, use the black spanner wrench supplied with the
machine. To remove, engage the spanner in the hole near the end of the bayonet fitting
and apply a sharp rap downward. Before putting on a fitting be sure the opening ends are
cleaned. Hand tightening is sufficient to hold the fitting in proper position.
N.B. When properly mounted, the bayonet fitting will tighten itself by rotating it in the socket
in the opposite direction of the sanding belt rotation.
HEEL BREASTER ON BAYONET:
A Heel breaster mounted on a quick change adaptor is provided with
your Sander and can be used on the left side of the main shaft.