Landis S-500, Руководство оператора

Страница: 2 / 32

1
Introduction
BEFORE USING THE LANDIS S 500 SANDER, READ
OPERATING INSTRUCTIONS MANUAL:
1. KEEP GUARDS IN PLACE and in working order.
2.
REMOVE ADJUSTING KEYS AND WRENCHES. Form habit
of checking to see that keys and adjusting wrenches are
removed from tool before turning it on.
3. KEEP WORK AREA CLEAN. Cluttered areas and benches
invite accidents.
4. DON'T USE IN DANGEROUS ENVIRONMENT. Don't use
power tools in damp or wet locations, or expose them to
rain. Keep work area well lighted.
5.
KEEP CHILDREN AWAY. All visitors should be kept safe
distance from work area.
6. MAKE WORKSHOP KID PROOF with padlocks, master
switches, or by removing starter keys.
7.
DON'T FORCE TOOL. It will do the job better and safer at
the rate for which it was designed.
8.
USE RIGHT TOOL. Don't force tool or attachment to do a
job for which it was not designed.
9.
DO NOT USE EXTENSION CORD.
10.
WEAR PROPER APPAREL. Do not wear loose clothing,
gloves, neckties, rings, bracelets, or other jewellery which
may get caught in moving parts. Nonslip footwear is
recommended. Wear protective hair covering to
contain long hair.
11.
ALWAYS USE SAFETY GLASSES. Also use face or dust mask
if cutting operation is dusty. Everyday eyeglasses only
have impact resistant lenses, they are NOT safety
glasses.
12. SECURE WORK. Use clamps or a vise to hold work when
practical. It's safer than using your hand and it frees both
hands to operate tool.
13. DON'T OVERREACH. Keep proper footing and balance at
all times.
14.
MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean
for best and safest performance. Follow instructions for
lubricating and changing accessories.
15.
DISCONNECT TOOLS before servicing; when changing
accessories, such as blades, bits, cutters, and the like.
16.
REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure
switch is in off position before plugging in.
17.
USE RECOMMENDED ACCESSORIES. Consult the owner's
manual for recommended accessories. The use of improper
accessories may cause risk of injury to persons.
18.
NEVER STAND ON TOOL. Serious injury could occur if the tool
is tipped or if the cutting tool is unintentionally contacted.
19. CHECK DAMAGED PARTS. Before further use of the tool, a
guard or other part that is damaged should be carefully
checked to determine that it will operate properly and
perform its intended function -- check for alignment of
moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its
operation. A guard or other part that is damaged should
be properly repaired or replaced.
20.
DIRECTION OF FEED. Feed work into a blade or cutter
against the direction of rotation of the blade or cutter only.
21.
NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER
OFF. Don't leave tool until it comes to a complete stop.
The S 500 Sander is a compact, durable machine designed for fast, complete finishing work. It will deliver efficient,
dependable service when used correctly and with care. As with any piece of specialized equipment, for best
performance the manufacturer’s instructions must be followed.