![background image](http://html1.mh-extra.com/html/landice/elliptimill-e8/elliptimill-e8_service-manual_3501682057.webp)
PAGE 57
Tools Needed:
Phillips Head Screw Driver.
Instructions:
1.
Release the brake cable from the controller. To do so, pull on the brake cable to
give it some slack, unwrap it around the white brake controller knob and pop it
out of the notch.
2.
Remove the two black phillip’s head bolts that hold the brake controller to the
bracket on the machine.
3.
Take the two screws out for the dc motor that’s located at the
base of the brake controller. Then slide the dc motor out of the
assembly.
4.
ENTER DIAGNOSTIC MODE:
•
ON ET’s: Press MENU & START simultaneously.
•
ON CT’s: Press NEXT & START simultaneously.
•
ON PT’s: Press DISPLAY & START simultaneously.
5.
Set the effort level screen to 20.0
6.
Turn the white knob for the pot counterclockwise until the reading in the display
reads 20.0.
**(See Fig. A)**
7.
Insert the brake cable back into the notch on the white knob, wrap it around in a
counterclockwise direction from the notch and bolt it back down to the machine
**(See Fig. B)**
Calibration Instructions for Brake Controller
Screws for DC
Motor.
Содержание ELLIPTIMILL E8
