Landice ELLIPTIMILL E8, Руководство по обслуживанию

Страница: 20 / 68

21. Clip the
harness to the (2)
harness clips along
the frame. Once
you have secured
the harness to the
clips, connect it to
the female
connector on the
lower electronic
board.
TIP: If
installing an LVS,
install the Caddy
(reading rack)
now. Then LVS,
then resume this
assembly (step
22).
22. Mount the
front cover. Use
the remaining
screws in hardware
bag "STEP 7" to
mount the cover.
NOTE: Use the
machine screws
(4) in the bag with
a dull point to
fasten the cover to
the frame (shown
in picture). Use
the remaining
sharp point screws
(8) to mount the
rest of the cover to
the silver side
covers.
23. Place the
membrane in the
control panel and
connect the two
harnesses coming
from the contact
hand grips to the
smaller board
located on the far
side of the
membrane. The
white connectors
can go on either of
the two available 3-
pin connectors. 24. Connect the
upper harness to
the upper board.
Center the
membrane and
pitch it back into
place so that the
velcro mates
securely. Connect
the main power
cord to the front
cover so you can
turn the machine
and verify all
electrical
connections.
PAGE 20