Land Pride RC4615, Руководство оператора

Страница: 33 / 68

Section 2: Adjustments
Table of Contents
8/22/23 RC4615 & RCM4615 Rotary Cutters 331-644M
29
Wing Deck Leveling
Refer to Figure 2-4:
Each wing section will need adjusting if wing top is not
level with center deck top when wings are unfolded.
1. With tractor hydraulics, lower wings down. Refer to
“Field Set-up” on page 36 for instructions on how to
lower wings.
2. Pull cutter straight forward six to ten feet to allow
outer wing wheels to properly align themselves.
3. Check wing tops to see if they are level with top of
center deck. If outer edge of either wing top is higher
or lower than the center deck, then that wing should
be leveled as follows:
a. If outer wing edge is higher than the center
deck, loosen jam nut (#1) & rotate turnbuckle (#2)
clockwise to lower outer wing edge until wing is
level. Tighten jam nut (#1) to the correct torque
when level.
b. If outer wing edge is lower than the center deck,
loosen jam nut (#1) and rotate turnbuckle (#2)
counterclockwise to raise outer wing edge until
wing is level. Tighten jam nut (#1) to the correct
torque when level.
Leveling Wing Decks
Figure 2-4
27926
1
2
Clockwise Rotation Shown
Center Deck Leveling
Figure 2-3
37633