Land Pride RC4615, Руководство оператора

Страница: 40 / 68

Section 3: Operating Instructions
Table of Contents
8/22/23 RC4615 & RCM4615 Rotary Cutters 331-644M
36
Transporting
WARNING
!
To avoid serious injury or death:
•
Always raise wings and set transport locks before
transporting from one work site to another and before
traveling on public roadways. The wings can fall if not
secured with transport locks.
•
Select a safe ground speed that will allow adequate control
of steering and stopping. Never exceed 20 mph (32 km/h)
with attached equipment. Rough terrain requires a slower
speed.
•
When traveling on public roads, use hazard lights, slow
moving vehicle sign, clean reflectors, and other adequate
devices to warn operators in other vehicles of your
presence. If implement blocks visibility of slow moving
vehicle sign, relocate sign so it is visible from the back at all
times. Always comply with all federal, state, and local laws.
•
Watch while making tight turns to ensure that the rear
tractor tires and lower 3-point arms do not make contact
with cutter hitch, driveline or deck. Keep lower 3-point
arms raised at all times when hitched to a pull-type cutter.
1. Select a safe ground speed when transporting from
one area to another. Maximum transport speed for
the Rotary Cutter is 20 mph.
DO NOT EXCEED .
2. Be sure to reduce tractor ground speed when turning
and leave enough clearance so the cutter does not
contact obstacles such as buildings, trees, or fences.
3. Always raise wings and set transport locks before
traveling on public roadways.
4. When traveling on roadways, transport in such a way
that faster moving vehicles may pass you safely.
5. Shift tractor to a lower gear when traveling over rough
or hilly terrain.
Road Side Cutting
When cutting road sides, Land Pride recommends the
Rotary Cutter be equipped with chain guards to stop
flying objects and Land Pride’s LED Light Kit to make
your self more visible. For additional information, refer to
“Safety Guard” on page 40 or the Parts Manual for LED
Light Kit information.
Field Set-up
WARNING
!
To avoid serious injury or death:
The following operational procedures should be carried out
by the tractor operator. Other persons should not be in the
area. All cutter operations including field set-up should be
stopped when other persons are in the vicinity.
Inspect Field and Cutter Blades
1. Thoroughly inspect area to be cut for debris and
unforeseen objects. Remove all potential hazards
and mark any that cannot be removed.
Refer to Figure 3-4:
2. Inspect wing blade carriers and cutting blades for
locked blades prior to lowering the wings. Use a pry
bar or other tool to separate locked blades.
Wing Deck Blade Positioning
Figure 3-4
IMPORTANT: Cutting should not be done in wet
conditions. Wet material will build up on the deck
underside creating additional horsepower, high
wear, and poor discharge.
IMPORTANT: Cutting blades may become locked
together (overlapped) when the wings are raised for
transport. Operating cutter in this condition will result
in severe deck vibration. Inspect wings for locked
blades prior to power-on operation.
27858
Blade Carrier
Wing Deck
Cutting Blades