Land Pride RC4610, Руководство оператора

Страница: 21 / 68

Section 1: Assembly & Set-up
Table of Contents
RC4610 (540 RPM) and RCM4610 (1000 RPM): Rotary Cutters: 334-144M: 1/14/19
17
Standard Clevis Hitch Hook-up
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking
implement. Keep people and animals away while backing-up
to implement or pulling away from implement. Do not operate
hydraulic controls while a person or animal is directly behind
the power machine or near the implement.
WARNING
!
To avoid serious injury or death:
The ball detent pin must be fully inserted into the park jack
with ball visible and popped out on the far side of the jack
before working on or around an unhooked cutter.
Refer to Refer to Figure 1-8:
1. Make certain park jack (#3) is properly attached to
the cutter hitch and secured with ball detent pin (#8).
2. If park jack angle is not vertical when attached to the
hitch, make adjustments to the jack using “Align
Park Jack Vertically” instructions on page 30.
3. Store center 3-point link in the tractor’s storage hook.
4. Start tractor, raise 3-point arms fully up.
5. Back tractor within close proximity of clevis (#9).
6. Shut tractor down properly before dismounting. Refer
to “Tractor Shutdown Procedure” on page 16.
7. Verify tractor drawbar is adjusted correctly using
“Drawbar Set-up” dimensions on page 14. If
needed, adjust tractor drawbar horizontally and
vertically.
8. Raise or lower park jack (#3) to align clevis (#9) with
tractor drawbar. Drawbar should fit between lower
and upper plates of clevis.
9. Restart tractor and continue to back tractor up to
cutter hitch until holes in tractor drawbar and clevis
hitch (#9) are aligned.
10. Shut tractor down properly before dismounting.
11. Customer to supply hitch pin (#1) and hairpin
cotter (#2). Insert hitch pin (#1) through top hole in
clevis (#9), tractor drawbar, and out through bottom
hole in clevis. If bolt (#12) is removed, add an equal
number of flat washers (#11) above and below the
drawbar to remove excess gap between drawbar and
clevis hitch plates.
12. Secure hitch pin (#1) with hairpin cotter (#2).
13. Lower cutter hitch with park jack (#3) until hitch
weight is supported by the tractor drawbar.
14. Remove park jack (#3) and attach it to the weight box
storage mount with ball detent pin (#8). Make sure
jack is stored with its base level or lower than the
head. See cover picture for correct positioning.
15. Attach hitch safety chain (#4) to tractor. Adjust chain
length to remove all slack except what is necessary
to permit turning. Lock chain hook securely to the
safety chain.
16. Continue with “Hydraulic Hook-up” on page 20.
NOTE: The 5/8" bolt (#12) and spacer (#13) may be
removed for more flexibility of the hitch. If bolt and
spacer are removed, an equal number of customer
supplied flat washers (#11) should be added above
drawbar and below drawbar to remove gap between
drawbar and clevis hitch. This will help reduce
drawbar and hitch wear.
IMPORTANT: Protect park jack by attaching it to the
weight box before moving the cutter. Make sure jack
is stored with its base level or lower than the head to
prevent water and freeze damage.
Tractor Hook-up to Standard Clevis Hitch
Figure 1-8
39193
37298