Land Pride RC4610, Руководство оператора

Страница: 30 / 68

Section 1: Assembly & Set-up
Table of Contents
1/14/19 RC4610 (540 RPM) and RCM4610 (1000 RPM): Rotary Cutters: 334-144M:
26
Lift Cylinder Mounting Position
Refer to Figure 1-22:
Lift cylinder (#1) should be mounted in one of the 3
following holes:
•
Hole (A) if cutter is equipped with 21" laminated tires.
•
Hole (B) if cutter is equipped with 25.5" aircraft tires.
•
Hole (C) if cutter is equipped with 29" aircraft tires.
Reposition lift cylinder if it is not assembled in the correct
hole:
1. Park tractor and cutter on a level surface.
2. Fully extend deck lift cylinder (#1).
3. Shut tractor down properly before dismounting. Refer
to “Tractor Shutdown Procedure” on page 16.
4. Dismount tractor and remove all stroke control
spacers (#4) from hydraulic lift cylinder (#1).
5. Place sturdy support blocks or jack stands under the
four corners of the center deck.
6. Return to the tractor seat and lower center deck onto
the support blocks until cylinder hitch pin (#2) is
loose.
7. Shut tractor down properly before dismounting.
8. Remove hairpin cotter (#3) and hitch pin (#2).
9. Reposition hydraulic cylinder to the correct mounting
hole (A or B) and reinsert hitch pin (#2). Secure hitch
pin with hairpin cotter (#3).
10. Return to the tractor and fully extend center deck lift
cylinder to raise the deck up.
11. Shut tractor down properly and dismount to replace
stroke control spacers (#4) and remove support
blocks from under the four corners of the center deck.
Adjust Light Assemblies
Refer to Figure 1-23:
The Light Assemblies may need adjusting. Adjust light
assemblies as follows:
1. Shut tractor down properly before dismounting. Refer
to
“Tractor Shutdown Procedure” on page 16.
2. On the right-hand light assembly (#1), loosen the
four hex locknuts (#3). Do not remove locknuts.
3. Slide right-hand light assembly (#1) and mounting
clamp (#4) as far as possible toward the rod end of
hydraulic cylinder (#2).
4. Tighten each locknut (#3) one-half turn in a criss-
cross pattern until all nuts are tightened to the correct
torque.
Refer to Figure 1-24:
5. Mount magnetic light assembly (#5) vertically on the
end of the weight box as shown with rear facing
amber light above the rear facing red light.
Lift Cylinder Mounting Position
Figure 1-22
Adjust Light Kit
Figure 1-23
Adjust Light Kit
Figure 1-24
39196
AMBER
RED
70609
AMBER
RED
70609