Land Pride LR3784, Руководство оператора

Страница: 20 / 30

16
Section 4: Adjustments
LR3784 & LR3796 Landscape Rakes 302-337M 2/26/16
Table of Contents
Section 4: Adjustments
Safety Alerts
!
CAUTION
Avoid injury from a falling rake. Always check to make sure all
hardware is secured properly before adjusting the rake.
!
CAUTION
Do not come in contact with turntables or stick objects into
turntable holes while adjusting rake offset or rake angling.
Doing so can pinch or shear body extremities and objects.
Rake Offset
Refer to Figure 4-1:
The rake may be offset in 15
o
increments up to 45
o
in
either direction for a maximum offset of 26" left or right.
1. Read and follow all “Safety Alerts” above.
2. The Landscape Rake must be hitched to a tractor
and raised off the ground several inches.
3. Rotate handle of bent pin (#3) 90
o
to the frame as
shown on Figure 4-2.
4. With handle rotated 90
o
, pull bent pin (#3) up until pin
is out of hole in hitch turntable (#1).
5. Hold bent pin up and rotate mainframe (#2)
clockwise or counterclockwise up to 45
o
in 15
o
increments.
6. Once mainframe (#2) is rotated to the preferred
angle, push bent pin (#3) fully down into one of the
turntable holes to lock mainframe in place.
7. See “Rake Angling” below if rake frame (#4) needs
to be angled to operator preference.
Rake Angling
The Landscape Rake can be angled manually up to 30
o
in 15
o
increments or hydraulically up to 45
o
. The optional
Hydraulic Cylinder Kit must be installed to angle the rake
with hydraulics.
Manual Angling
Refer to Figure 4-2:
1. Read and follow all “Safety Alerts” above.
2. Pull bent pin (#2) from hole in mainframe.
3. Rotate rake (#1) to the desired angle and reinsert
bent pin (#2).
IMPORTANT: Never angle rake frame or rake teeth
into the tractor tires. This can damage the rake and
tractor tires.
IMPORTANT: The Landscape Rake must be hitched
to a tractor and raised off the ground several inches
to make adjustments.
NOTE: To adjust rake offset, bent pin (#3) must be
fully out of hole in hitch turntable (#1).
Hydraulic Angling
Refer to Figure 4-2:
1. Read and follow all “Safety Alerts” above.
2. Move tractor control lever forward to retract the
hydraulic cylinder and rearward to extend the
cylinder.
3. If cylinder operates in the opposite direction, switch
quick disconnect couplings at the duplex outlet.
Rake Offset
Figure 4-1
Rake Angling (manual shown)
Figure 4-2
NOTE: Make certain bent pin (#2) in Figure 4-2 is
removed before operating the hydraulic cylinder.
39419
Offset shown with rake angled parallel to hitch frame.
39420