Land Pride LR3784, Руководство оператора

Страница: 16 / 30

12
Section 2: Accessory Equipment Set-up
LR3784 & LR3796 Landscape Rakes 302-337M 2/26/16
Table of Contents
Hydraulic Angling Kit
Refer to Figure 2-5:
The Hydraulic Angling Kit can be easily attached to the
Landscape Rake to make adjusting the rake angle
easier.
!
DANGER
Do not remove cap screw securing rake pivot cap without
supporting underside of rake. The rake will fall if not
supported and can cause serious injury or death.
1. Support rake by lowering unit to the ground. If
unhooked from a tractor, make sure park stand is
rotated down and secured.
2. With rake supported to keep it from falling, remove
hex flange cap screw (#8), pivot cap (#9), and drive
pivot cap (#10). Keep nut and pivot cap for reuse.
Store drive pivot cap (#10).
3. Attach hydraulic angling plate (#4) to rake pivot
shaft (#18) with pivot cap (#9) and 3/4"-10 x 1 1/2"
GR5 hex flange cap screw (#8), 1"-8 x 6" GR5 bolt
(#3), and hex flange top lock nut (#6). Do not tighten
lock nut and cap screw at this point.
4. Remove bent pin (#19) and store with hex drive pivot
cap (#10).
IMPORTANT: Never fully extend or retract hydraulic
cylinder without first checking to make sure the rake
does not make contact with tractor tires.
5. Attach adapter fittings (#13) to one end of hydraulic
hoses (#11 & #12) and tighten.
6. Attach quick disconnect couplings (#21) to adapter
fittings (#13) and tighten. (Quick disconnect
couplings are furnished by customer).
7. Position hydraulic cylinder (#17) with ports on top
and cylinder base to the front as shown. Screw 90
o
elbows (#7) into the cylinder ports and tighten facing
forward as shown.
8. Attach short hydraulic hose (#12) to elbow (#7) at the
cylinder base and tighten.
9. Attach long hydraulic hose (#11) to elbow (#7) at the
cylinder rod end and tighten.
10. Attach base end of hydraulic cylinder (#17) to the
cylinder mount plate (#14) on the main frame with
clevis pin (#15) and cotter pins (#16). Make sure
hydraulic ports are positioned on top and cylinder
base is positioned to the front as shown.
11. Attach rod end of hydraulic cylinder (#17) to the
hydraulic angling plate (#4) with clevis pin (#1) and
cotter pin (#2). Place 1/2" spacer (#20) between the
rod end of the cylinder and the hydraulic angle lug
(#5) as shown.
12. Tighten lock nut (#6) and hex flange cap screw (#8)
to the correct torque.
IMPORTANT: Attach cylinder base towards the front
of the unit as shown. The base will interfere with the
main frame if assembled wrong.
Hydraulic Angling Kit
Figure 2-5
39441