Land Pride DB26 Series, Руководство оператора

Страница: 47 / 60

Section 6: Maintenance & Lubrication
Table of Contents
5/24/19 DB2660 & DBM2660 Ditch Bank Rotary Cutter 316-317M
43
5. If replacing dishpan (#4), castle nut (#10) on gearbox
output shaft should be torqued to 550 ft-lbs. minimum
and secured with cotter pin (#11) with both legs bent
opposite directions around the nut.
Ditch Bank Cutter Blade Assembly
Figure 6-2
Blade Rotation (Viewed From the Top)
Figure 6-3
37323
Use 1-11/16"
Socket Wrench
On Blade Nut (#3)
Land Pride Cutter Blade Parts
Item Part No. Part Description
318-586A BLADE BOLT KIT
(Includes items 1, 2, & 3 below)
1 802-277C BLADE BOLT 1 1/8-12 x 3 7/16 WITH KEY
2 804-147C WASHER FLAT 1 HARD ASTMF436
3 803-170C NUT HEX TOP LOCK 1 1/8-12 PLATE
4 316-124H DISHPAN WELDMENT SPCL-HUB
5 820-112C CUTTER BLADE 1/2 x 4 x 25 CW
37331
Blade Bolt
Access Hole
Long Term Storage
Clean, inspect, service, and make necessary repairs to
the implement when storing it for long periods and at the
end of the season. This will help ensure the unit is ready
for field use the next time you hook-up to it.
1. Clean extension arm and inside surfaces of support
boom of grass and other debris. See
“Extension
Arm” on page 45 of detailed instructions.
2. Clean off any dirt or grease that may have
accumulated on the deck, deck motor, and on any of
the moving parts. Scrape off compacted dirt from the
bottom of the deck and then wash the surface
thoroughly with a garden hose.
3. Check blades and blade bolts for wear and replace if
necessary. See
“Cutter Blade Maintenance” on
page 42.
4. Inspect for loose, damaged, or worn parts and adjust
or replace as needed.
5. Lubricate as noted under “Lubrication Points” on
page 44.
6. Apply a generous coat of lubrication to all 4 sides of
the extension arm and all four inside surfaces of the
support boom. See
“Extension Arm” on page 45 of
detailed lubricating instructions.
7. A coating of oil may also be applied to the lower deck
area and to any exposed hydraulic cylinder rods to
minimize oxidation.
8. Store the cutter in a clean, dry place with deck
positioned on a flat surface.
9. Disconnect tractor from Ditch Bank Cutter. Refer to
“Unhook Ditch Bank Cutter” on page 40 for
detailed instructions.
10. Replace all damaged or missing decals.
11. Repaint parts where paint is worn or scratched to
prevent rust. Aerosol touch-up paint is available from
your Land Pride dealer.