Land Pride DB26 Series, Руководство оператора

Страница: 35 / 60

Section 4: Adjustments
Table of Contents
5/24/19 DB2660 & DBM2660 Ditch Bank Rotary Cutter 316-317M
31
Frame Leveling Left to Right
Refer to Figure 4-3:
Usually the cutter frame is leveled left to right as follows:
1. Place a level (#1) across the top of the reservoir as
shown to verify levelness.
2. Manually adjust one or both of the tractor’s lower
3-point arms up or down until reservoir is level.
The right 3-point arm can be raised and left 3-point arm
lowered to clear embankments that otherwise would
cause driveline angle to exceed 25
o
to clear the
embankment. Refer to “Angle Problems With Driveline”
below.
Frame Leveling Left to Right
Figure 4-3
37346
Angle Problems With Driveline
Refer to Figure 4-4:
The driveline angle can not exceed 25
o
when raising
3-point arms to clear embankments. Refer to “Check
Driveline Interference” on page 22 for driveline
interference instructions. When driveline angle exceeds
25
o
, manually adjust lower 3-point arms as follows:
1. Adjust right arm up and left arm down an equal
number of turns to raise deck pivot point higher than
the embankment.
IMPORTANT: Be careful to avoid hitting uneven
ground and raised objects with cutter frame (#1),
parking stand (#2), and deck pivot point (#3) when
traveling with 3-point arms set at different vertical
lengths.
Frame Angling to Clear Embankment
Figure 4-4
37347