Storage:
&W
Command
Command Values:
AT+LCNOER=0
Send ERROR response to unknown commands.
AT+LCNOER=1
Send OK response to unknown commands
6.20 AT+LCPAST Pass Unknown v.250 Commands To The Cellular Module
Enables or disables pass-through of v.250 commands that the Intelligent Modem’s v.250
command interpreter does not recognize (i.e. any command not specifically listed in this
document) to the digital cellular module.
Default:
0
Storage:
&W
Command values:
AT+LCPAST=0
Return ERROR or OK to unknown commands as per the
AT+LCNOER setting.
AT+LCPAST=1
Forwards
only
unknown commands to the internal RF
module. All recognized AT commands are executed by
the RISC processor.
AT+LCPAST=2
Pipe all commands to the internal RF module utilizing
UART #1.
AT+LCPAST=3
Pipe all commands to the internal RF module utilizing
UART #2
7.0 Session Management Commands
This
Session Management
section details the commands designed to facilitate connecting
via the cellular network. In many cases, use of these commands is not required, but will
allow much more flexibility, especially when connecting via 1xRTT.
7.1 AT+LCPRFL Profile Configuration
The AT+PRFL command allows one to configure up to three different dialing profiles
with such parameters as: Packet Data, Simple IP/Mobile IP, Username, Password, and
TCP/UDP connectivity, to name a few. There are a total of nine command line
arguments, denoted below as arguments number 1.) through 9.).
Default:
1,0,atd# 777,,,-1,0,,232
2,0,atd#777,,,-1,0,,232
3,0,atd#777,,,-1,0,,232
Storage:
Automatic
Command values:
AT+LCPRFL=
<parameters listed below>
Defines a profile as per settings below.
AT+LCPRFL?
Queries all current profile settings.
Argument Num ber/Type
Parameters
1.) Profile Number:
1=First Saved Profile
2=Second Saved Profile
3=Third Saved Profile
