147
W
A
RNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
ST
AR
TING
AND DRIVING
IN AN
EMERGENCY
Versions with alloy rims
❒
Check that the hub contact sur-
faces are clean;
❒
fit the normal wheel centring it on
the pins, lead in the fastening
screws and tighten them using the
wrench provided;
❒
lower the car and remove the jack;
❒
using the wrench provided, fully
tighten the bolts in the sequence
shown in
fig. 15
.
❒
snap fit the wheel cup on the hub.
When you have finished
❒
stow the spare wheel in the space
provided in the boot;
❒
fit the jack partially open in its
box forcing it lightly to prevent it
from vibrating when travelling;
❒
put the tools back into their places
in the container;
❒
arrange the container and tools in
the spare wheel and secure the fas-
tening device;
❒
rearrange the preformed boot
cover correctly.
WHEN NEEDING
TO CHANGE A
BULB
GENERAL INSTRUCTIONS
❒
When a bulb is not working, check
that the corresponding fuse is in-
tact before replacing it: refer to the
“If a fuse blows” paragraph in this
chapter for fuse location.
❒
before changing a bulb check the
contacts for oxidation;
❒
burnt bulbs must be replaced by
others of the same type and power;
❒
always check the height of the
headlight beam after changing a
bulb.
Halogen lamps must be
handled holding the metal-
lic part only. Touching the
transparent part of the bulb
with your fingers may reduce the in-
tensity of the emitted light and even
compromise duration of the lamp it-
self.