lancer Sensation, Руководство по эксплуатации

Страница: 9 / 28

9
Dispenser Installation
1. Install unit to counter.
2.
Remove the splash plate and top cover.
3. Remove the merchandiser by removing the two (2) screws
located on the faucet plate (from left to right) above the third
(3rd) and sixth (6th) valve.
4. Remove the drip tray and cup rest.
5. Route appropriate tubing from the water source to the plain
water inlet at the front of the unit and connect tubing to inlet
using the oetiker pliers and fittings, (see Plumbing Diagram
on the front of the unit or on page 25 for reference).
DO NOT PLUG UNIT INTO GROUNDED ELECTRICAL
OUTLET AT THIS TIME. Make sure that all water lines
are tight and unit is dry before making any electrical
connections
!
WARNING
Both drain lines must be insulated with a closed cell
insulation. Insulation must cover the entire length of
the drain hose, including fittings. The drain should be
installed in such a manner that water does not collect
in sags or other low points, as condensation will form.
!
CAUTION
Pouring hot water into drain may cause the Drain Tube
to collapse. Allow only luke warm or cold water to enter
Drain Tube. Pouring coffee tea and similar substances
into drain may cause the Drain Tube to become
clogged with coffee or tea grounds, or other solid
particles.
!
ATTENTION
12. Route drain hose from designated open type drain to fitting
on Drip Tray and connect hose to fitting.
13. Reattach Drip Tray/Cup Rest to unit.
6. Route appropriate tubing from the remote carbonator to the
carbonated water inlet and connect tubing to inlet.
7. If no remote carbonator is installed, install the carbonator
per manufacturer’s instructions.
8. Connect tubing to water source then flush water lines to
check for leaks
9. Route appropriate tubing from the syrup pump location to
the syrup inlets in front of the unit and connect tubing to all
inlets.
10. Route appropriate tubing from the CO
2
source location to
the CO
2
inlet at the remote carbonator location.
11. Route the power supply cord to a grounded electrical outlet
of the proper voltage and amperage rating.
A
B
C
A. Oetiker Pliers
B. Fitting
C. Tubing
D. Syrup/Water
Inlet
D
A
A. Drain Fitting
B. Drain Line
C. Drip Tray
B
C