16
Extended lengths of product lines may require more
time to flush and rinse lines.
NOTE
Cleaning and Sanitizing Syrup Lines - Bag in Box
1.
Disconnect the syrup quick disconnect coupling from the
syrup packages and connect the coupling to a bag valve
removed from an empty Bag-in-Box (BIB) package.
2.
Place syrup lines, with BIB connectors, in a bucket of warm
water.
3.
Activate each valve to fill the lines with warm water and flush
out syrup remaining in the lines.
4. Prepare Cleaning Solution described on page 13.
5. Place syrup lines, with BIB connectors, into cleaning
solution.
Following sanitization, rinse with end-use product until
there is no aftertaste. Do not use a fresh water rinse.
This is a NSF requirement. Residual sanitizing solution
left in the system creates a health hazard.
!
CAUTION
6.
Activate each valve until lines are filled with cleaning
solution then let stand for ten (10) minutes.
7. Flush out cleaning solution from the syrup lines using clean,
warm water.
8. Prepare Sanitizing Solution described above.
9. Place syrup lines into sanitizing solution and activate each
valve to fill lines with sanitizer. Let sit for ten (10) minutes.
10.
Reconnect syrup lines to BIB’s and draw drinks to flush
solution from the dispenser.
11. Taste the drink to verify that there is no off-taste. If off-taste
is found, flush syrup system again.
4. Unhook the spring from the upper ice chute by pulling up
and out.
5. Remove the lower chute by carefully spreading apart the
arms of the lower chute.
Ice Chute Cleaning
It is recommended to perform this procedure monthly,
or more often if desired. Use the cleaning solution
described on page 13. An alternate solution of one
part water to one part vinegar may be used to remove
water spots and calcium deposits.
NOTE
Always remove the ice chute lever before removing
the splash plate.
NOTE
1.
Turn off power to the dispenser.
2. Remove Merchandiser.
3. Remove Ice Chute Lever, then remove Splash Plate
Assembly by lifting it up and out from the dispenser face.
6. Prepare the Cleaning Solution.
7.
Soak the lower Ice Chute Assembly in the solution.
8. Using the Cleaning Solution and the sponge brush provided,
clean the inside of the upper and lower chutes.
9.
Rinse and dry the lower and upper Ice Chute Assembly
thoroughly.
10.
Reinstall the lower Ice Chute Assembly.
11. Reinstall Merchandiser and Splash Plate.
12.
Reconnect power to the dispenser.
A. Lower Ice Chute
B. Pull Tabs Out
A
B
B
A. Ice Chute Lever
A
