10
If regulator does not utilize a knob, use a wrench to
loosen the lock nut then a screwdriver to back out the
screw and close the regulators.
NOTE
1. Connect high pressure CO
2
regulator assembly to CO
2
cylinder or bulk system.
-
Thread regulator nut on to tank, then
tighten nut with wrench
A. CO
2
Regulator
B. Outlet
C. Wrench
D. CO
2
Supply
A
B
C
D
Before installing regulator, assure that a seal (washer
or o-ring) is present in regulator attachment nut.
!
ATTENTION
A. CO
2
Regulator
B. Line to CO
2
Inlet
at Unit
A
B
A. CO
2
Regulator
B. Regulator Knob
A
B
A dedicated CO
2
regulator is required to supply the
carbonator on the unit as well as to all syrup pumps.
!
ATTENTION
Installing CO
2
Supply
2. Connect appropriate CO
2
tubing to inlet on regulator then
route tubing from the CO
2
regulator to the CO
2
inlet at the
unit.
6. Turn the knob on the CO
2
regulator, at the source, all the
way to the left (counterclockwise) to close the regulator.
Repeat for CO
2
regulator at the syrup pumps.
DO NOT TURN ON CO
2
SUPPLY AT THIS TIME
!
WARNING
5.
Route appropriate tubing for CO
2
from CO
2
regulator at syrup
pumps to all syrup pump CO
2
inlets.
A. CO
2
Regulator
B. Wrench
C. Lock Nut
A
C
B
3. Connect tubing routed from CO
2
regulator at the source to
the CO
2
Inlet at the unit.
4.
Install tee fitting to CO
2
line and route additional line to CO
2
regulator at syrup pumps.
A
B
D
C
A. Tee Fitting
B. Line to CO
2
Source
C. Line to Syrup Pump
CO
2
Regulator
D. Line to CO
2
Inlet at Unit
A. CO
2
Line
B. CO
2
Inlet
A
B
