lancer FLAVOR SELECT 22, Инструкция по установке и обслуживанию

Страница: 27 / 40

27
P.N. 28-0580/02
4. TROUBLESHOOTING
TROUBLE CAUSE REMEDY
CONTINUED ON NEXT PAGE
4.1 No product when switch is
activated. (Switch panel does not
light up when activated.)
A. Keyswitch is off, or keyswitch
harness is disconnected.
B. 9-in valve harness is
disconnected.
C. Defective switch assembly.
D. No power to unit.
A. Turn keyswitch on and/or
reconnect keyswitch harness.
B. Turn off power, reconnect 9-pin
harness, and restore power.
C. Replace switch assembly.
D. Check internal breaker and
incoming power.
4.2 No product when switch is
activated. (Switch panel does light
up when activated.)
A. 25-pin valve harness is
disconnected.
B. Defective switch assembly.
A. Turn off power, reconnect 25-
pin harness, and restore power.
B. Replace switch assembly.
4.3 Push chute and nothing
happens.
A. Dispenser not connected to
power source.
B. Microswitch defective.
C. Wiring harness not plugged in.
D. PC board defective.
A. Connect dispenser to power
source.
B. Replace microswitch.
C. Plug in wiring harness.
D. Replace PC board.
4.4 Push chute. Ice door opens
but motor does not run.
A. Wiring harness not plugged in.
B. PC board defective.
C. Motor defective.
A. Plug in wiring harness.
B. Replace PC board.
C. Replace motor.
4.5 Push chute. Motor runs but
ice door does not open.
A. Solenoid not connected to PC
board.
B. Solenoid defective.
C. PC board defective.
D. Solenoid bracket screwed too
low and not opening completely.
A. Connect solenoid to PC board.
B. Replace solenoic.
C. Replace PC board.
D. Unscrew solenoid bracket,
raise solenoid and rescrew
bracket.
4.6 Push chute, ice door opens,
motor runs, but no ice dispenses,
or ice is of poor quality.
A. Dispenser is out of ice.
B. Agitator pin is missing or
damaged.
C. Poor ice quality.
A. Fill unit with ice.
B. Replace agitator pin.
C. Install water
filtration/purification to icemaker
supply water.