Dropin 1522 Bargun
www.lancerbeverage.com
Page 9 of 25
Hoshizaki Lancer reserve the right to change specifications without notice.
Part No 68000014
Images are for illustration purposes only as product may vary.
No 030b-12 August 2013
Caution
The Drop In is not suitable for use in subfreezing temperatures.
To prevent damage to the water supply line, turn off and drain
unit when air temperature is below 0
o
C.
Warning
Installation should only be performed by a qualified and
competent technician.
1. The counter must be strong enough to support 80kg with a 570mm x 390mm cut out in it.
2. A 3-pin, Earthed 230V / 10 Amp GPO; potable water supply, regulated CO2 supply and
drainage must be accessible.
3. For best performance the unit should be mounted away from potential heat sources such
as heaters, under-counter refrigeration, dish washers, etc.
6.4 Assembling the FlexiCarb.
The preferred method of mounting the FlexiCarb to the Drop In is provided as an integral
solution. Mounting holes and hardware are provided on the underside of the Drop-In.
1. Ensure there is sufficient clearance (> 710mm) under the counter for the Flexicarb to be
mounted to the drop in.
2. Set the Drop In upside down on the floor or counter to access the underside.
3. Mount the Flexicarb as shown with the screws and washers provided.
4. Locate the Tee fitting on the DropIn and connect the pump inlet as shown. Trim the tube
to suit the installation but make sure to leave excess (>75mm) insulation to insure
adequate coverage of the tube connection and prevent condensation.
5. Locate the Soda Inlet to the Drop In and connect carbonator outlet to it. Repeat Step 4
above trimming the tube but keeping a generous excess of insulation to work over the
connection when finished.
Refer to Label for correct connections
4. Tee to Pump
3. Screw + Washer x 4
5. Carb to
SODA IN
