![background image](http://html1.mh-extra.com/html/lancer/delta-iii-9100-series/delta-iii-9100-series_operation-manual_3515316014.webp)
6. TROUBLESHOOTING
9
PROBLEM
CAUSE
REMEDY
6.1 Miscellaneous leakage.
A. Gap between parts.
B. Damaged or improperly installed
o-rings.
A. Tighten appropriate retaining
screws.
B. Replace or adjust appropriate o-
rings.
6.2 Insufficient water flow.
A. Insufficient incoming supply water
pressure.
B. Foreign debris in water pump.
A. Verify incoming supply water pres-
sure is a minimum of 25 PSI.
B. Remove water pump strainer and
strainer. Clean.
6.3 Insufficient syrup flow.
A. Insufficient CO2 pressure to BIB
pumps.
A. Adjust CO2 pressure to 80 PSI
(minimum 70 PSI) for BIB pumps.
6.4 Erratic ratio.
A. Incoming water and/or syrup supply
not at minimum flowing pressure.
A. Check pressure and adjust, as
necessary.
6.5 No product dispensed.
A. Electric current not reaching
electric valve
B. Improper or inadequate water or
syrup supply.
C. Transformer failure.
A. Check electic current supplied to
valve. If current is adequate, check
solenoid coil, and switch. Replace, if
necessary.
B. Remove valve from mounting block
and open shutoffs slightly and check
water and syrup supply. If no supply,
check dispenser for freeze-up or other
problems.
C. Reset transformer circuit breaker. If
breaker pops again, refer to Item 6.23.
6.6 Water only dispensed, no syrup;
or syrup only
dispensed, no water.
A. BIB supply too far from dispenser.
B. CO2 pressure too low.
C. Stalled or inoperative BIB pump.
D. Kinked line.
A. Check that BIB supply is within six
(6) feet of the dispenser.
B. Check the CO2 pressure to the
pump manifold to ensure it is between
70-80 PSI.
C. Check CO2 pressure and/or re-
place pump.
D. Remove kink or replace line.
6.7 No water just syrup. (Ice bank
grew to water inlet line to
carbonator tank.)
A. Low level.
B. Unit not level.
C. Syrup in water bath.
All water. Refill. Locate
and repair.
D. Water cage is out of position.
E. PCB relay sticking.
A. Add water until it flows from over
flow tube.
B. Level unit and add water.
C. Melt ice bank and remove
possible syrup leak area.
D. Reposition water cage.
E. Check continuity of compressor
relay. Compressor should time-out
in five (5) minutes.