![background image](http://html1.mh-extra.com/html/lancer/delta-iii-9100-series/delta-iii-9100-series_operation-manual_3515316010.webp)
1.12 CONNECTING THE CO2 SUPPLY
A. Connect high pressure CO2 regulator assembly to CO2 cylinder. Use a new CO2 tank washer if
regulator does not have built-in o-ring seal.
B. Place CO2 cylinder in service location under counter, etc., and secure it with a safety chain.
C. Using tubing and fittings from installation kit, connect tubing assembly to tank mount regulator
using flare seal washer (PN
). Use a back-up wrench to prevent damage to regulator
assembly.
D. Route gas line through hole in counter and through opening behind the dispenser splash plate.
E. Leave 12 inches (30 cm) of extra tubing length below the counter for servicing and moving the
dispenser.
F. Remove the protective plug from the CO2 manifold (located on top of mini pumps on left side of
unit) and connect the CO2 supply line using a 1/4 inch elbow (supplied in installation kit.)
G. If dispenser does not have built in syrup pumps, connect directly to the carbonator CO2 inlet
check valve.
1.13 CONNECTING TO BAG-IN-BOX (BIB) SYRUP SUPPLY (Units with Built-in Syrup Pumps)
A. Remove the protective caps from the syrup pump inlets and connect syrup inlet tube
assemblies, furnished in the installation kit, to the syrup pumps. Lubricate o-rings before
installation, using food grade glycerine or equivalent. Be careful not to cut o-rings when installing
in pump.
B. Mark syrup tube assemblies at BIB hose connector end with product ID tape.
C. Route the syrup supply tubes from the unit, through hole in counter, to the BIB syrup supply.
D. Dip hose connectors in a cup of warm, potable water.
E. Attach the BIB hose connectors to the appropriate syrup flavor.
1.14 CONNECTING TO REMOTE BIB SYRUP PUMPS
A. Locate the remote BIB, syrup supply, and pumps in a convenient location.
B. Attach the syrup supply tubes to the dispensers syrup inlet fittings (located behind the splash
plate) using a 1/4 inch Oetiker clamp for each syrup flavor.
C. Route the syrup supply tubes to the remote syrup pumps.
D. Complete installation of the remote syrup pump system following the manufacturer’s
instructions.
1.15 CONNECTING TO REMOTE PRESSURIZED SYRUP SUPPLY
A. Locate the five gallon (figal) syrup containers and the CO2 cylinder and regulator set in a
convenient location.
B. Attach the syrup supply tube assembly to the dispensers syrup inlet fittings (located behind the
splash plate) using a 1/4 inch Oetiker clamp for each syrup flavor.
C. Route the syrup supply tubes to the figal syrup containers and attach them to the appropriate
syrup flavor.
D. Attach a CO2 supply line from each of the figal syrup containers to the low pressure regulator
and pressurize the containers.
5
!
WARNING
DO NOT TURN ON THE CO2 SUPPLY AT THIS TIME
!
CAUTION
THE SYRUP INLET TUBE ASSEMBLIES SHIPPED WITH THE INSTALLATION KIT,
ARE EIGHT (8) FEET (2.4 M) LONG. THESE LINES CAN BE EXTENDED UP TO A MAXI-
MUM OF 12 FEET (3.7 M). THE MAXIMUM HEIGHT OF THE PUMPS ABOVE THE LOWEST
BIB PACKAGE SHOULD NOT EXCEED EIGHT (8) FEET (2.4 M). IF EITHER THE HEIGHT
OF PUMPS OR LENGTH OF INLET LINE LIMITATIONS ARE EXCEEDED, REMOTE SYRUP
PUMPS OR PRESSURIZED SYRUP CONTAINERS SHOULD BE USED.