CLEAN PRODUCT LINES
Remove hoses from bucket, then reconnect hoses to product bags.
Press next to prime hoses with product.
8/10
Back
Home
Main Menu
Next
CLEAN PRODUCT LINES
Prepare bucket of sanitizer, place end of hoses in bucket,
press next when ready.
6/10
Back
Home
Main Menu
Next
CLEAN PRODUCT LINES
Prepare bucket of cleaner, place end of hoses in bucket,
press next when ready.
4/10
Back
Home
Main Menu
Next
CLEAN PRODUCT LINES
Once hoses are disconnected from product bag, use spray bottle
filled with sanitizer, to clean connections on product bag.
2/10
Back
Home
Main Menu
Next
The unit will begin flushing warm water through the
product lines. Each pump will run for one whole cycle
(approximately 25 seconds) to ensure lines are
completely flushed of any remaining product.
The unit will begin to fill the product lines with
cleaning solution. Each pump will run for one whole
cycle (approximately 25 seconds) to ensure lines are
completely flushed of any remaining product.
The unit will begin to fill the product lines with
sanitizing solution. Each pump will run for one whole
cycle (approximately 25 seconds) to ensure lines are
completely filled with sanitizing solution.
The unit will begin to fill the product lines with the
original product. Each pump will run for one whole
cycle (approximately 25 seconds) to ensure sanitizing
solution is completely flushed from the system.
NOTE
NOTE
NOTE
NOTE
8. Using a soft cloth or sponge, clean the product line
connections on all of the product bags with sanitizing
solution, then press Next.
9. Empty and replace jar in Blend Station, if needed.
10. Place ends of product hoses into a bucket of cleaning
solution then press Next.
11. Let cleaning solution sit in lines for ten (10) minutes before
continuing.
12. Empty and replace jar in Blend Station, if needed.
13. Place ends of product hoses into a bucket of sanitizing
solution then press Next.
14. Let sanitizing solution sit in lines for ten (10) minutes before
continuing.
15. Empty and replace jar in Blend Station, if needed.
16. Replace product bags and trays.
17. Reconnect product hoses to their corresponding product
bags then press Next.
18. Taste each product to verify there is no off-taste.
19. If off-taste is found, flush the product system again by using
the Manual Controls option, (See Manual Controls Section,
page 10).
20. Press and hold each product number for one whole cycle
(approximately 25 seconds) to ensure off-taste does not
occur.
Following sanitization, rinse with end-use product
until there is no aftertaste. Do not use a fresh water
rinse. This is a nsf requirement. Residual sanitizing
solution left in the system creates a health hazard.
!
CAUTION
15
