INSTALLATION
Unpacking the Dispenser
Dispenser Installation
1. Cut package banding strap and remove.
2. Open the box and remove the accessory kit and loose
parts.
3. Remove top board, corner inserts and lift outer carton to
remove, if included.
4. If leg kit has been provided, assemble legs by tilting unit.
Inspect unit for concealed damage. If evident, notify
delivering carrier and file a claim against the same.
DO NOT LAY UNIT ON ITS SIDE OR BACK
Drain fitting must be installed with adequate backflow
protection and any other necessary equipment to
comply with federal, state or local codes. It is
recommended that rigid or reinforced tubing is used
for installation.
DO NOT reuse beverage tubing, installer should
provide new beverage tubing that meets IEC Standard
61770. Lancer beverage tubing kits are available for
purchase. Contact your Sales Representative or
Lancer Customer Service for more information.
NOTE
!
ATTENTION
!
ATTENTION
!
CAUTION
1. Connect the two (2) 3/4 inch garden hose fittings supplied
with the unit to the cold/drink water inlet and the hot/rinse
water inlet.
2. Route appropriate tubing from the water source to the cold/
drink water inlet on the back of the unit.
3. Turn on water source and flush water supply line
thoroughly.
4. Using tubing Cutters, cut the cold drink water line and install
an in-line watet filter with a flow rate of at least 1 gallon
(3.78 liters) per minute.
5. Route appropriate tubing from the hot water rinse fitting to
hot water source and connect tubing to inlet.
6. Turn on water supply and check for leaks.
7. Locate the 1 inch (25.4 mm) PVC bulkhead fitting on the
rear of portion of the unit.
8. Loosen the nut on the drain fitting and install the 1.0 inch
(25.4 mm) O.D. smooth wall tubing drain pipe and retighten
the nut to seal against the tube.
Leave 12 inches (305 mm) of extra tubing below the
counter for servicing and moving the dispenser
NOTE
9. Locate the product line inlets in the refrigerated portion of
the unit.
Each line is labeled “1-8” for identification purposes.
These labels correspond to the pump numbers as
found on the front of the pump cube and as used
during system/drink programming.
NOTE
6
A. Hot/Rinse Water Inlet
B. Cold/Drink Water Inlet
C. Drain Inlet
A
B
C
A. Hot/Rinse Line
B. Cold/Drink Line
C. Drain Inlet
D. Oetiker Pliers
E. Garden Hose Fitting
A
B
D
E
C
