6
CONTINUED ON NEXT PAGE
Lancer PN: 28-1005/01
8. Feed the power wires (blue and brown) of the LED
Driver through the opening in the Control Box.
9. Plug the positive (blue) and the negative (brown) wires
of the LED Driver into their appropriate positions on
the central connection terminal.
10. Re-attach the control box cover.
11. Remove existing wiring diagram from control box
cover and replace with new wiring diagram included
with kit (06-4002).
12. Connect the LED Driver Jumper Wire to the LED
Driver then, using the adhesive clips provided, route
the jumper wire to the top left side of the unit.
Jumper wire not needed for 22” configurations.
NOTE
If a water button installation is required, refer to the
water button installation instructions (Lancer PN: 28-
3016) before going on to step 13.
NOTE
13. Secure the Light Panel Assembly in place by inserting
the connection tabs of the Light Panel Assembly into
the slots, horizontally, on either side of the
Merchandiser Frame Assembly.
14. Once the connection tabs are inserted into the slots,
pull down on the Light Panel assembly to secure the
connection tabs into the slots on the frame assembly.
15. Plug the LED Driver cable, routed in Step 12, to the
LED Light Panel Jumper Cable.
16. Plug-in the unit to test light panel operation before
completing merchandiser assembly.
