5
CONTINUED ON NEXT PAGE
Lancer PN: 28-1005/01
Installing LED Light Panel
1. Using a screwdriver, remove the two screws on the left
and right side of the unit. Save screws for later use.
If necessary, use self-tapping screws to create custom
hole pattern when attaching LED Driver to unit.
NOTE
Remove protective film from sheet metal before in-
stalling to the unit.
NOTE
If unit is equipped with an icemaker whose face plate
extends past the front edge of the dispenser, the Frame
Assembly may not fit correctly. Shift the icemaker so
the front edge does NOT extend past a minimum of a
1/2 inch clearance from the front edge of the dispenser.
!
ATTENTION
7. Using the two (2) screws supplied with the kit, attach
the LED Driver to the top of the unit, onto the manual
ice fill zone.
2. Slide the left side Frame Assembly behind the valve
plate along the left side edge of the unit.
3. Positioning the panel to it’s lowest point possible, use
two (2) of the four (4) screws removed in Step 1 to
attach the left side Frame Assembly to the unit.
4. Repeat steps 2-3 for the right side Frame Assembly.
5. Slide the back, hooked tabs of the top Frame
Assembly into the back slots of the left and right side
Frame Assemblies.
6. Firmly press the front tabs of the top Frame Assembly
and push down to secure in place.
Edge of
Icemaker
1/2”
clearance
