4
SECTION 4 – INSTALLATION
4-1. TECHNICAL DATA:
o
Device suitable for welding in dry rooms.
o
Mains voltage ~230 V / 50-60 Hz +/-15%
o
Mains fuse T2,5 A
o
Power input 500VA
o
Operating voltage 20-38 V
o
Open circuit voltage 38V
o
Max. loading time 1,7 seconds
o
Protective gas min. Argon 99.9 %
(ARGON
4.6)
o
max. gas pressure 10 bar
o
Protection class I
o Insulation
category
B
o
Protection type IP20
o
Weight 6,8 kg
4-2. TYPE LABEL CHART
Description of symbols:
Amperes
Volts Spannung
Degree Of
Protection
Hertz
Alternating
Current
Gas Tungsten Arc
Welding
Direct Current
Gleichstrom
1 ~ 50-60Hz
Line Connection
1 Phase /
Alternating
Current / 50-60Hz
Note Manual
Conventional
Load Voltage
Primary Voltage
Protective Earth
(Ground)
Spannun
Rated Welding
Current
One phase
transformer
Rated Maximum
Supply Current
Maximum
Effective Supply
Current
Duty Cycle
4-3. SETTING UP
•
Place the device so that cool air can reach the entire
outside surface without difficulty
•
Do not cover the device!
•
Always place the device on a hard non-combustible,
insulated material base.
•
Do not allow metal dust (e.g. during abrasion work) to
directly enter the device.
