Lambrecht rain[e]observer, Руководство по эксплуатации

Страница: 2 / 44

rain[e]observer Operating Instructions
Operating Instructions
rain[e]observer Precipitation Measuring System
Table of Contents
1 General safety information 4
2 Warranty 4
3 Disposal 4
4 Introduction 5
5 Operating principle 5
6 Scope of delivery 5
7 Choosing the installation site 5
8 Connecting cables for rain[e] precipitation sensor and heating 6
9 Initial operation 7
9.1 General 7
9.2 Wiring the rain[e] as rain[e]observer · Internal connection diagram 8
9.2.1 Opening the housing 9
9.2.2 Changing the wiring 9
9.2.3 Closing the housing 9
9.3 Configuration of the rain[e] as a rain[e]observer 9
9.4 Installation of the rain[e] at the installation site 11
9.4.1 Choosing the installation site 11
9.4.2 Assembly 11
9.4.3 Integrated collection container 12
9.5 Installation of the observer module 15
9.6 Installing the mast mount for the traverse 16
9.7 Connecting the rain[e]observer - Connecting the system cabling 17
9.7.1 Connecting cables to the observer module and the rain[e] 17
9.7.2 Connection diagram 18
9.8 System start 18
10 rain[e]observer protocols 18
10.1 SDI-12 interface 18
11 Modbus protocol 27
11.1 Data encoding 27
11.2 Device address 28
11.3 Standard configuration - default 28
11.4 Modbus command set 28
11.5 Measured value and parameter register Lambrecht sensors 29
11.6 Special case of precipitation amount 30
11.7 Sensor status 30
11.8 Descriptive sensor parameter register (holding register) 31
11.9 Sensor parameters / configuration parameters 31
11.10 Autoconfiguration 32
11.11 Total amount of precipitation 32
11.12 Pulse output 32
12 Changing the communication protocol 32
2