-12-
www.igmtools.com
IMPORTANT:
If the lathe is not level
1. Make sure the lathe is mounted to the stand.
2. Make sure floor is flat.
3. Loosen all 16 bolts holding height position pillars and tool rack to
relieve all gaps.
4. Retighten all bolts.
IMPORTANT:
If using the mobility kit, please remove the two rubber feet
closest to the two stationary wheels of the mobility kit.
Fig. 28
FAQ
Q: What is the height range with this stand?
A: The Revo 1216 Stand allows the spindle center line to be positioned at
7 different heights from 990 mm (39“) to 1143 mm (45“).
Q: Does this come with the mobility kit?
A: No, it comes standard with rubber pads.
IGM LAGUNA Mobility Kit for 1412-14BX-1216
Order code: 151-1412MBA
Compatibility: 151-1216STA, 151-1412, 151-14BX
Fig. 29
Fig. 30
Fig. 30: Mobility Kit for Revo 1216 Lathe. (1) Base Wheels &
mounting. (2) Foot Lever and Wheel Mount Assembly
Mobility Kit Setup
WARNING! Unplug the machine from power source!
TIPDo not over torque the threading, only firm pressure is required.
TIP Revo 1216 Adjustable Stand must be purchased to use the
Mobility Kit.
Receiving
It is likely that your machine will be delivered by a third party. Before
unpacking, be sure to inspect the packaging and shipping documents
supplied by the driver. Ensure that there is no visible damage to the
shipment. If any damage has occurred because of shipment, note the
damage on the bill of lading or refuse the shipment. Immediately call the
dealer store where the machine was purchased.
1. Never accept a shipment that is damaged or partial without notifying the
shipping company and the purchasing store.
Stand unpacking
Once in place, carefully unpack and remove all components.
Unpacking guidelines:
1. Do not cut deep into a box with a blade as it could scratch the paint.
Only cut deep enough to cut the tape or use a dull edge.
2. Organize the hardware and setup tools needed prior to proceeding with
setup.
Fig. 31
Fig. 32
Fig. 32: Unpacking (1) Contents. (2) Unpacked Contents. (2.1)
Stationary Wheels. (2.2) Foot Pedal Assembly. (2.3) Support Plate.
(2.4) Foot Pedal Caster. (2.5) Hardware. (2.6) Foot Pedal Spring. (3)
Swivel Axle.
Stationary Wheels
Same Spacing
REMOVE RUBBER PADS
FROM THE BASE
