laguna MT01002, Руководство пользователя, Страница: 31 / 49

Motor tries to start but will not turn
1.
With the power disconnected from the machine, try to turn the shaper
spindle by hand. If the spindle will not turn check the reason for the
jamming. Typical reasons are spindle lock engaged, cutter head
contacting the shaper fence or table rings.
2. Motor faulty. Replace the motor.
3. Motor break engaged.
Motor overheats
The motor is designed to run very hot, but should it overheat, it has an
internal terminal overload protector that will shut it down until the motor has
cooled down and then it will reset automatically. If the motor overheats wait
until it has cooled down and restart. If the motor shuts down, constinstantly
check for the reason. Typical reasons are dull blade, overfeeding the wood,
motor cooling fan clogged or faulty, motor cooling fins clogged, Break
engaged and excessive ambient temperature.
Squeaking noise
1.
Check that the motor cooling fan is not contacting the fan cover.
2. Check the bearings.
3. Check the drive belt.
Cutter slows down during a cut
1.
Loose drive belt. Re-tension the belt.
2. Dull blade. Replace the blade or have it re sharpened.
3. Feeding the wood too fast. Slow down the feed rate.
4. Oil or dirt on the drive belt. Clean or replace the drive belts.
Cutter overheats
1.
Dull blade. Change the blade or re sharpen the blade.
Machine vibrates
1.
Machine not level on the floor. Re-level the machine ensuring that it
has no movement.
2. Damaged drive belt. Replace the belt.
3. Cutter head unbalanced.
Poor dust collection
1. Check the capacity of the dust collection system. You need a minim of
1000 cubic feet per minute at the machine. The stronger the dust
collection the better.
31