laguna MT01002, Руководство пользователя, Страница: 29 / 49

Do not attempt this procedure unless excessive movement has taken place
during shipping.
1. Lock the sliding table in position with the table lock knob.
2. Using a straight edge across the sliding table check the gap between
the straight edge and the main table at both ends of the man table.
3. If adjustment is needed loosen the lower nuts ¼ turn only. Do not
loosen the top nuts
4. Adjust the top nuts so that the gap under the straight edge is parallel
and at about 0.02”.
5. Check that all the top nuts are in contact with the support steel and
that there is no rocking.
6. Tighten the lower nut and re-check. If fine-tuning is required, repeat
the procedure.
Sliding table adjustment for bearing /
steel rod clearance
The sliding table mechanism is designed with
8 ground steel rods; ball bearings run
between the steel rods. The table comes
factory set but if there is excessive side
movement, adjustment can be made as
follows:
1. Extend the table to one end. The ball
carriage will be at the opposite end.
2. Move the table side to side to check for excessive movement.
3. Loosen the allen screw [X] and tighten allen screw [Y]. The screws
must be adjusted in pairs and 2 pairs of screws cover the range of the
ball carriage.
Note: The screws should be adjusted in small steps as damage could be
caused.
Note: The [X] screws must be tight before you check for side movement.
4.
Move the table so that the next two pairs of screws are covered by the
ball carriage and repeat the adjustment procedure.
Screw “Y”
Screw “X”
Sliding table ball bearing
clearance adjustment
Remove end
cover
5. Continue until all the
screws have been
adjusted.
Sliding table ground steel
rods damaged or worn
Steel rods Clamp screws
If the steel rods become
damaged or worn, a new face
can be presented to the ball
bearings as follows:
29